Home > Safety Device > Panel PC Type Load Monitoring Device [SCMATG] -  Press Breaker Alarm Usually, an over-load protector is installed on a press machine to protect the machine. The capacity of the press machine differs according to the slide position. The practical protection of the press machine can be performed by this function. This function is also performed by the former Loadgard, but its function is improved and the operation can be easily done by inputting by the supervisor. For the practical load monitoring. >> See More Picture -  Tracking Alarm Not only the monitoring of the upper and lower limit values of the peak load but also the monitoring of the load changes during the processing can be performed. It is instrumental to discover abnormal relations between angle data and load values by inputting angle data from the resolver. It is the most suitable function for monitoring the load of complex processing or the load of a drawing when employing die cushions. >> See More Picture -  Peak load value monitor The peak load value of every corner and the total load values will be displayed on this monitor. Each function can be selected by touching the function part displayed on the lower part of the screen. This screen is designed to display four channels. -  Load wave display screen This screen can display the load waves of the four corners and one corner. Operation is very simple, you just touch the part (the screen) of the corner you want to know about, and you can get its load wave. If you want to know more about it, you can trim it. -  Partial zooming is also available. The most suitable function for analyzing the forming load changes of the drawing. Supply Voltage 100V AC Auto-Zero Balance - Resolver Input Since/Cosine 12bit Resolution of Resolver 0.1 degrees Max. Operating Speed 600 SPM A/D Sample 200 micro sec Communication Port RS422/485 (for AUTOGRAPH), RS-232C Ethernet Port, Parallel Port for Printer Recorder Output 0 to 4V