Home > Safety Device > Strain Monitoring Die Protection System [RDM-3] This is an error detector that uses a Strain gauge sensor as the die monitor. It monitors dies for troubles and will stop the press machine if double stamping, slug rising or slug clogging occurs, by processing the original operation with the analog waves outputted per stroke from the Strain gauge sensor installed on the press machine frame. It has demonstrated superior capability in the detection of slug clogging or slug rising in the dies with the trunk that has long been considered difficult to detect. The detection effect can be increased when our MICRON II High Resolution Slug Detecting Device is used at the same time. -  Easy to handle -  After the exchange of dies, it only requires the operator to press the setup button to restart their work. If a finer adjustment of monitoring scope is required, we can offer you upper and lower limits buttons and a setting dial for such requirement. -  This is an interactive-Type liquid crystal screen, so even an inexperienced person can operate it easily. -  Original technology This device is perfectly suited for the detection of slug clogging or slug rising in the dies with the trunk that has been considered difficult to detect. -  Easy to Maintain -  The Sensor will be installed on the press machine itself, so it does not require the operator to adjust the Sensor or timing whenever dies are exchanged. -  It supports extensive scope of error detection, which includes the detection of slug rising, slug clogging, double stamping, starving, feeding error, etc. Power supply voltage 100 to 240VAC +10%,-10% Power consumption 15W Response speed Display 600rpm, stopping capacity 2000rpm Display values Workload (integral values) Sensors Two mold-type strain sensors Temperature drift None (-5 to 60)(Celsius) Analog output 0 to 5V (left and right load waveform) External dimensions 115 (H) x 218.5 (W) x 167 (D) mm